I'm working on a 500 HP stock engine x15 cm2350 Efficiency series. I been studying Rawze advice. I wanted to know if it's good idea to set liner...
This what i was wonder...but vapors are still regulated. Hence you can't get rid of the placards. Unless they are purged and certified. You have...
I think cop told them answer and wasnt' correct.
Yes i know.. I think it sounds stupid and illegal. But I dont' know everything. I'm also HAZWHOPPER trained and have my class A X and tanker.
This is the question. The driver trainee does have his hazmat endorsement. For class B Hazmat tankers. He wants to upgrade to class a. Can the...
Can a trainee driver who has a class B with tank and hazmat endorsement. Can that trainee driver get a CDL permit for A and drive a Placard hazmat...
I have a 2007 pete high beams not working. High beam indicator is not coming on. If you jump the dual fuse to the light they work good. Low beams...
Ok that's what I wanted to know a price on railed. I figure it's a 15000 to 30000 repair to do it right. Going to send it to frame shop.
Original frame is extended to fit a tank so you need one oem plus fab the extension on. It's like they extended the frame to make it a dump...
About what I thought thanks for info.
One of our trucks came in to get air bag fixed. I we notice it had cracked frame develop at the torsion bar location on front rear axle. Also the...
Do local route drivers of Propane and fuel, have 12 hours rule 100 air mile radius? My boss says we aren't required to follow hours of service. We...
I have a mercedes benz 900 engine in a FL frieghtliner. I'm waiting on the 16 serrated socket to coming in to removal the flywheel. I wanted to...
I'm think exhuast, injector or jacob because if jacobs use can dampened or cure for a 10 seconds....I was wonder if injector could do that. They...
I have N14 with a light tick that developes after 1 hrs worth of using it. Its seems to be on the back box and goes away for 10 second after using...
No i would say it just start to rumble....just like a rawww....rawww.....rawww.....then fan kicks on and goes right away.
I have N14 that rattles rymthic when the AC is turned on ac clutch engaged. It goes away when off or when the AC is on but fan is clutch is...
Well that's good news. I thought it looked like the Oil regulator was just cutting back pressure and i was reading the manual and it says it...
Rebuilt a N14 Celect Plus cummins. My Oil pressure bounce up to 65 when fired up immediately(2 second or so) then settle right on 35 on manual...
Funny story I was super picky and pressure washed the bell housing and steam clean in a parts washer...It has 1 inch thick of gum oil grease...
