Ok so the temp dropped to -5F this weekend. As I went to go get groceries for the week, I noticed My truck (MBN) has an active drip and a small...
I have 3 questions. 1. Is this a dot infraction? The other bolts are tight and it's not leaking. 2. Am I destined to break more if I leave it...
You wouldn't want to run up here. I've never made it through an inspection without getting a warning or citation Most times the fines are $300.
Can anyone tell me how difficult it is to remove the fuse panel, and more specifically repair or replace a bad connection? After 2 weeks of...
I used to run the mountains about 50% at nights. I was more than willing to spend 700 to be able to see. The stock halogens are trash. Not...
Also, I would blue thread locker on the mounting bolts. About half of mine loosened off after 1 logging season.
I've since sold that truck. But I did get condensation in the one side. The light still worked good and it seemed like the condensation would...
So some good news, the bulb was not pushed ask the way in. So I can confirm the ECM has power and the lights and relays are all working....
Currently there is no light, no wiring from the sensors, and it looks the the air brake valve is a no abs type
No I didn't check the light. I will, I wish it would be that simple. I'm almost certain the PO removed a lot of the components and wiring .
Can anyone tell me where I would find the module? I've got no abs light at all.
Well I just wanted to thank everyone,. I got it taking grease. I ended up filling the grease hole and a short length of pipe full of penetrating...
Thanks, I'm working on the upper pin on the driver's side, the pin should unscrew counter clockwise? (lefty loosy).
Thanks for the link, I guess what I'm wondering is how hard is it to back out the pins? Can it be done with a wrench or do I need a special...
I recently bought a 2004 t800, it's not in service yet,. So as I was going through it and greasing everything, one of the shackle pins won't...
Ok I was wrong, it's a TRW. I'm not sure what I was smoking. It's tightened up to 300ft lb. The free play is gone.. Next week I'll get a...
I'll take a pic. This morning.
Its not TRW. I'll try Kenworth to get the specs but in my experience they are very tight lipped unless you are buying parts or getting...
hi , I have some freeplay in the pittman arm on my t800. I am going to buy a new bolt and locknut to replace it . Im guessing the ft/b to be...
The last 2 yrs , I have a steady reefer run from April till July, then I've hauled logs till till spring again. I am mostly looking at getting...
