I’m wondering what pressure I should actually be getting to the gate cylinders?
I grease them up good. Got to where it’ll barely go up even if I push to get it going. It’s for sure an air issue.
This won’t even try to open unless I push hard on the gate. And it’s basically brand new
I probably worked it up and down 10 times. Didn’t seem to want to get any better with each cycle.
Well I guess I had it figured out already. Latches and gate work off same switch. According to load king themselves. Flip the switch and latches...
No sir I haven’t started tearing panels off just yet. I got the latches to open but no luck on the gate.
Hello I just bought a 2021 load king half round. Coming from a belly dump. I can’t figure out how to get the tailgate working. Belly used a round...
I was wondering the same thing.
Do you have any idea where I could get a writing diagram for the starter?
The starter has the exact one on it. This one was mounted of the frame as well. Not sure what its used for. Having the #### electrical fault...
[ATTACH] Chasing wiring again........ Has anyone seen this remote mounted on the frame right next to the starter? Came to dealer was just gonna...
Reared it's head again yesterday. Lock outta gear and display code 37. Sat for an hour and worked. Took it to the yard. Any specifics that yall...
Sorry for the long delay in replying. Truck went down for some other stuff. (Long story). But we cleaned every wire harness connection, every...
10/4 I'll try it here in a bit. I'll post back this afternoon!
Transmission is displaying code 13 for J1939
On a side note this trailer we are pulling has the abs dash light on constantly. Any way possible this could be causing stuff to go hay wire? Long...
10/4. It's stuck out in the field now stuck in drive. I had this problem a few years back with it was the x-y shifter. But yeah I'm thinking it's...
10/4 where is that transmission tcu located at just to check the connections as well. Would that cause the electrical fault warning also?
OK wanted to give it a bit before I replied. I started by changing the mega fuses, cleaned all the connections on that junction area on the...
10/4 I'll be sure and reply with what I find. Thank you.