I went with the lisle 18000. There are several brands that sell something similar
Rear motor mounts on mine
Ride height is important and can cause vibration. Check all your springs, u bolts air bags
Motor mounts affect drive line angle so check the front as well and check carrier bearing. Short of that, find a shop that has a vibration...
Check your drive line and all u joints. Check if it does it in neutral or just in gear Check if it does it while pulling, cruising and coasting
Which way is it out? Front to back can be fixed by loosening ubolts and using a ratchet strap to pull it forward or backwards (the axle)
Just totally disconnected napa setup. Underneath that fitting is a splitter. The dealer sells them. Call the dealer and see what fuel splitters...
All I have currently attached. From this fitting above the front of the transmission to the ecm cooler then the fs1000[ATTACH][ATTACH] [ATTACH]
First off , I made changes again. Honestly having fuel run to the hot side of the motor is a terrible idea. I removed the primary napa filter and...
Looking for a driver determined to be an owner operator. You absolutely have to know the ropes of otr. You will know what every load pays up front...
Are there actually non profits out there that just give you free cdl training? Seems unlikely. Might be some tax payer funded options with the...
They are indeed terrible at everything except enriching themselves and overcharging their customers.
Working on a star right now. I do like many things about it. There are some well thought out design features. First time playing with one.
So, at the spedo we have battery power but no ignition power. There is a good ground with no back feed from anywhere. On pin 4 with the lights on...
Had the #### plug backwards. From the schematic . Managed to get photos of the plugs in just the right light...[ATTACH] [ATTACH] Starting over...
Data star corrections. Pin 1 & 6 should have ignition power from spl-20 fed by fuse f-20. I'll check the fuse in the morning.
Deleted
Larger photo[ATTACH]
Spl 4-0 is my problem area.
I numbered them before I had a schematic. Now I have another photo and have relabeled them but didn't post it yet