0958 or 0955 dont use 57s with that cam
just fit IPD steel one piece pistons and be done with it. Cat articulated pistons with aluminum skirts are rubbish
Borg warner non waste gates 78mm with 1.45 rear housing. set of 58s (2113024) injectors and 7cz 600hp file it will make 550-580 to the grounds....
MBN C15 file 500hp 1650 torque
c18 can have c15/16 jakes fitted. best to run 70 pin with 6nz or 7cz file on the 18 with the correct turbo and injectors for power level
40psi must have a BW non wastegated turbo. get someone else to flash a pre clean power 550 file
trim codes reverting and not loading into the ECM is typically seen with incorrect date and time. Can also on occasion be seen with the ECM losing...
if the part number is the same it can be used regardless. even if its off of a machine. if it is off a machine and is flashed with CDL protocol...
21psi?
can anyone tell me what software PDI are using to tune the C15 ACERT engines?
use IPD 16:1 acert replacement kits. or C17 kits
No it should idle smooth enough to sit your coffee cup on the engine and not spill any. But most cat reman injectors won’t do that. And the...
If top cup seals Leak you’ll have diesel in the coolant. If bottom seal leaks it will pressurize the cooling system with combustion gasses
It’s wrong on so many levels. But it adds power and you won’t see the damage/shortened service life for some time. So people do it. It’s very...
hot trims are sometimes entered as a way of adding power. it stretched the pulse width and injection window in relation to crank position. Its...
ACERTS aren't the best for oil consumption and blue smoke. I personally use the late SDP prefix rings with the 164xxxx middle ring on 16:1 IPD...
did the miss start after you fitted new injectors or after the ECM & harness swap?
stan original cooling jet is fine. standard rocker shaft studs are fine, just torque to spec. if you get the ECM tuned just get them to delete...
ACERT use a different TPS. if it still has your original 40pin ECM it wont work as the ACERT injectors are different plus the ACERT has IVA and...
make sure its the correct part number and not programmed for earthmoving equipment with CDL data link