Just a thought, secondary tank, old air bags (dry-rotted areas until rolled out full).
again my bad on your delete, symptoms are the same, thanks.
Also forgot to mention head gasket (possible/probable), just re-living my bad luck, thanks.
Seen this and lived it. Does it regen good (complete, i.e. Davie) and the coolant is still the original red color? because that will eliminate the...
Just a thought, try a dab of RTV on new sensor when installed or zip tie. Had 2 where heavier than normal vibration (damper) caused the "placement...
Ha, ha... was that TIT Grad or I-Phone Grad (YouTube), what a face plant! ("I'm your huckleberry").
I guess my screen shot won't open that wide, I see nothing at the top. Not sure why any value would post other than the one that matters but I'm...
I've done ours with a pressure washer that has a diesel heater but I'd suggest first trying a couple things, your temp sensors, your outlet temp...
Look at that document you posted, it says "outlet temperature -40", I'll tell you right now that your #3 (top) temp sensor isn't plugged in or...
Just a few things that always apply; When changing DPF, always clean the DOC, this is where the chemical reaction takes place to generate the heat...
Now your talking about a DPF pressure differential and not EGR pressure differential, you should be able to view these in a "monitor" session and...
"Soot level most severe" can only be cleared with a completed regen. I understand this, all egr systems shut down automatically when there is an...
Okay you have a gen 1 system (easier), all I said previously still applies but let me ask you why you changed the dpf? time, maintenance requirements?
Again just trying to cover a few bases here, all engine related performance codes need to be cleared prior to regen and all prerequisites met for...
In regards to your EGR delta pressure code, this needs to be addressed also. The tubing or piping (venturi) could very well be clogged up...
My next question would also be that while you replaced the dpf, did you clean the DOC?
I'm confused about the word "purged" and I want to be clear about the fuel doser and NOT the def doser. You actually removed the fuel doser and...
Obviously your not reaching the temperatures required for a successful regeneration and normally step one would be supplying fuel to you fuel...
Should be something very similar.
Whatever "Event" occurred initially you now have a Can-buss issue that involves your Data-link connector, need to identify and verify ALL...