Anyone know the gear ratios of a Spicer 1241CT auxiliary transmission?
Like I said that 444 we had already converted it to high flow and I removed the wcac when I did that and I could not tell a difference at all in...
Would it not be the same amount of oxygen feeding the engine just a little warmer?
I have a 1989 international 9300. It had a tired, million + mile 444 Cummins engine that I just pulled to swap for a 1991 mechanical N14 from a...
That's what I was told but haven't messed with it yet.
But to get it out does the harmonic balancer/crankshaft pulley have to be pulled off with a puller or will it unbolt and come right off?
I cranked my 1985 Peterbilt 359 yesterday morning and noticed a puddle of oil under it after only a few minutes. My front crankshaft seal appears...
So injectors are set at 90 inch/lbs using the OBC correct? It's been a while for me
My engine is a 1989 NTC-444, CPL 1210. Is the OBC method with injectors set at 90 inch/lbs & valves at .11&.23 my best bet? I've tried the IBC...
I have a 1989 444 big Cam. Over 1.1 million miles as low flow. Started running hot recently. We replaced the radiator, water pump and clutch fan....
Look in my tanks for what? I already said there was oil in the tanks. No injector replacement recently. We I framed this truck around 125,000...
Yes, I'm definitely figuring that it's
2003 International 4700 dt466e. On a 2 hour trip yesterday the low oil pressure warning went off. I immediately pulled over and shut it down. No...
Mines not intercooled. I cut oil return line in half, put a compression fitting on with an off the shelf braided line from local industrial supply...
Here's mine.
That turbo is actually for a 3406e but like I said, if you modify the oil lines, it'll bolt right on a 3406b also.
Read all the earlier posts in this thread. Most of the info is here already. I put that very same turbo on my 7fb 3406b about two years ago. Minor...
