i investigated the issue this after noon with vice grips and soapy water and didnt find nothing even when i pinched line off the sound in the cab...
i gather that from everything i've read but how do i determine which one it is? there is no air leaking or nothing, everything is working fine
Working on my IH workstar and during harvest it developed a squeel hiss when the button is pushed in but goes away when pulled to engage brake,...
i have this 2008 IH Workstar truck and lately when i turn the key to let the gauges cycle it doesn't work i sometime have to jiggle it around to...
no I never changed those sensor I cleaned them when I was working on things before, I took off every cable and wire I could find even cleaned the...
i had an issue a while back I posted on here and the truck was cutting out down the road never can make it do it siting still, I took most the...
bit of an update Its still not working properly I've replaced the throttle position sensor and checked more wiring it all seems fine, I stopped...
i changed the throttle position sensor on my foot pedal and curious if there is a calibration or anything I read somewhere you had to push the...
my cruise and jake brake haven't really worked for awhile as much as i'd like them to it will work 1 time and not the next
@AModelCat I've seemed to narrow the problem down to where when the truck is really running hard like up and hill is when it cuts out it doesn't...
hey everyone quick questions, the wire that had a bare spot it comes off the ground post on the battery as one wire then goes into a connector...
batteries alone when unhooked at cleaning were all 11.5 each and truck running voltmeter shows just shy of 14 volts Truck is running good now i'm...
The ABS is for the trailer been on since I hooked onto this trailer my mechanic told me not to worry about as it a common thing
the alternator gauge just starts to go down and then comes back to 13.5 when engine kicks back I don't think It ever reaches 0 cause the engine is...
worked on it for a few hours the things I've found are in the neg side the small white wire has a bare spot in the middle from the 2 part...
I kinda wondered but I didn't see anything wrong with it I also had the truck at my shed kinda parked on a bit of a slope and I was checking...
runnin my IH 9900 with the 60 series Detroit ran fine hauling last week now when you given it and right around shifting rpms it cuts out the check...
Thanks a lot that was the problem I thought I checked them all but that was the problem mine had a 25 amp one in it I didn't have the right one...
interesting I don't think I pulled that one I checked all the other breaker ones and not sure how to check relays, I better go check that fuse...
I ran a load in this morning and the blinkers were working when I left home and went to turn off the highway and I got nothing tried the hazards...
