Like Mr Haney said it should produce 27 psi boost. Please try and find the problem before you add mods or ecm tuning. If you don't you'll still...
Yes, I saw one of these in Jackson MS a few years ago. I only noticed it because we were in the plant unloading. That is the only one I have seen....
Hi, I recently talked with Cris with Microblue. I would like to have differentials done as soon as I get my 85 Pete back on the road and get a...
Download from the roadranger site your trans and a higher rated torque. You'll find 90 percent of the parts are the same part number. You should...
Does it still have the MVT cam followers or regular? What was it timed at and where did you have it re-timed at?
I am building a Big Cam III using 20/40 lower press fit liners, 14.5 Dual Ni Resist pistons and .77 cam timing. It seems that the 14 to one...
I agree, headbolt is most likely. The old big cam's did this.
Did they have coolers on them? Not many did.
Peterbilt in Bossier had a glider this morning. Was not there in the afternoon according to my driver.
To answer you question, yes the engine will bolt up exactly the same. Should be a straightforward update. Is the N14 a mechanical or electronic...
Hi, Are you having problems with the NTC 475? I am rebuilding an NTC in my 85 Pete. Hope to have it in next week.
How did the 0958's perform? I have a set that I have yet to put in, just wondering. thank
I'd like to help, I have both metric and RTO that I have built for my own trucks, not sure of the rules in this forum for selling stuff:biggrin_2556:.
It can be a crap shoot. That's why I started building my own spares so when one went out, I wouldn't be in a bind. If you find a used one I...
I plan to purchase one or two gliders this next year. They will be powered by Cat 2WS 3406E engines and RTX16710C transmissions. Rear gearing will...
I recently swapped a 525 into my 379. The ecm must be flaky. If I tighten the bottom screw on the ecm for the truck harness, it runs erratically....
Travis, Is this a 475hp engine? I would cover the basics in no particular order. That is to make sure the air to air doesn't leak. Over head is...
I am thinking about putting in 58's in my 575 hp C-16, anyone have any idea how much it would bring up the torque or hp?
DDS, Would this cam be the same or close to one for a 475hp 2ws engine? Do you know what the compression ratio for these pistons? Are they two...
Da*m I love your graphic! We used religiously to watch the three stooges every day at 3PM in college. Curly Mo and Larry, and not to forget Shimp!