Have a 2013 Maxxforce 11. Only when cold and after air builds and purges, air pressure drops 5-10 psi on secondary tank after a minute or so and...
Yes. Offering reimbursements for improved replacement parts to EGR system for Maxxforce 11 and 13. Unfortunately all filing deadlines have passed.
That was it Heavyd. Removed all battery connections and 100a fuses to the cab at the firewall, cleaned and reconnected them but then had no power...
Instrument cluster goes dead-gauges frozen in place until reset. 10 speed manual. No headlights, just emerg flashers and dome light work. Good...
Have a 2013 Transtar MF 11 that loses all ignition switch power while driving-like the ignition switch was turned off. Still have flashers and cab...
Thanks for the info-especially the link
That is what I have now because of the lift. Wheel cut is now reduced to the right is increased to the left.
2013 TransStar 8600-I added a leaf to the front springs and blocks to raise the truck about 4”. This caused my steering wheel to be a bit to the...
Thanks-I narrowed my search to International and that may of been the problem
2013 8600 water truck-added a front leaf and 2” blocks to raise the front end and get the fuel tanks more off the ground. Can’t find an adjustable...
I read in my application packet FAQ that this could be delayed if counter lawsuits are filed against the settlement. I’m not expecting a...
Thanks-I found a source on the firewall-just making sure it’s hot all the time.
Thanks Headyd. Is the new feed hot all the time, like directly from the battery?
Have a 2013 MF 11. Having problems locating the power source for the intake air heater fuel solenoid. Had code 5548-5, the solenoid is good. There...
I had the same problem. Make sure the T air line connector between the two solenoids is facing down. Drove me nuts for awhile.
An update on something I discovered today-after cold start, if I turn on the cruise control, the engine stays at normal idle. A lot less annoying!
I have a 2013 Transtar with Waco 1200 System Saver air dryer. There is an air check valve on a T fitting right out of the dryer. The other side of...
Have a 2013 MF 11 with variable electronic fan clutch. Stupid thing runs at unlikely times, which I found out is “normal”. Everyone knows I’m...
Have a 2013 MF 11 that continues to blow white smoke after passive regen for a few minutes. Good power, no codes. Had engine health report done-on...
My 2013 Transtar 8600 with MF 11 air compressor cycles way to much. Compressor loads after 4-5 miles on the highway with no brake application. At...
