Family owned out of West Virginia. They make their own hardware and I get to keep it. Im done with the big corporations. Blue Ink Tech
Do yourself a favor and stay as far away from motive as possible unless you like giving your money to a foreign owned corporation that doesnt give...
I got a chance to mess with this thing again and I put the hose on the suction side of the pump in a bucket, primed it and it fired right up, ran...
So all installed. I went ahead and replaced pre transfer pump lines as well. Same problem still. Engine runs on hand prime these sputters out. I...
I would never force it. I did compare the plunger lengths. They are the same. As I barred the engine I could feel the cam lobe turning inside the...
I've checked everything from tanks forward. It all appears to be good. I'm still betting on the pump. I got the transfer pump in yesterday and am...
10 4. Thanks for that.
So, ive pulled all the lines from the tanks, including the tee, to the transfer pump. Nothing is plugged up or restricted. I blew out the hoses...
I haven't had a chance to do much diagnosing yet, Ive been on the road. After talking to some folks I'm leaning towards obstruction in a line or...
No. It sputtering and dies regardless of throttle input. The filters remain full
So I have an 8pn mech C that yesterday while I had the truck idling cold it started sputtering chugging with white smoke and died. It wouldn't...
I'm almost done up front, which should be complete today, then i will be headed to the back. A few updates there, most notably is the rear leaf...
Well, I got it figured out. After some looking around I found an adapter that goes from JIC to ORFS to fit the industrial C oil feed line. The oil...
You might find that combo trailers have a lot of rivets holding the deck rails together. Make sure they are not broken. Especially at the front...
After trying 3 different headrests this is by far the most comfortable even with glasses. It's not bullky and doesn't press against the ear. It...
I will when I get back to the shop Monday.
The problem is the end that bolts to the turbo. It's a funky one off triangular block thing
As I am going through my project truck I found that I needed to replace the turbo on my 8PN 3406C. I hung an aftermarket E model 177148 on there...
This is for the haters... I never said anything about turning it up, as I am not going to do that. I can do what I need at 425. The turbo doesn't...
Surprisingly the fuel tanks are immaculate inside. The fuel lines look relatively new. I didn't test them as I have no reason to believe they are...