Check your air tanks, they may have a valve stem and can be aired up like a tire.
The old timers would charge per mile whatever the fuel cost per gallon. The 1/3-1/3-1/3 deal works out too. Shorter loads need to do a day rate.
As the fan motor wears out it pulls more amperage which is what heats up the wiring. Sometimes the replacement harness will be heavier gauge wire...
Could have pulled the throwout bearing out of the pressure plate.
If the noise increases frequency as the rpm increases could be a tooth broken on a gear.
I took a simple driving test in a dump truck and they upgraded me to a commercial license in the 1970s in texas. Later they came up with the cdl...
I had that happen one time except opposite. Ran good with full tanks bad with lower fuel level. Problem was bad fuel that would stay above the...
I had a 3408 pc that got around 4.5 mpg. Had a 3406 dita that got around 5. Bought a new pete in 91 with a 3406 b ataac that got 5.5. Every change...
Plug it in if it has a block heater. Should help some if the fuel is not gelled.
Eaton website has info on a lot of there stuff for free. Put in the trans model number and should have an air troubleshooting tree for your...
On an eaton 10 speed you have an air pressure regulator and a slave valve, never heard of a solenoid. I would start with finding and repairing the...
I dont know on your truck if it has a dedicated ck valve or uses the reed valves in the compressor itself.
Should have a one way ck valve that lets air flow to the compressor but not the other way.
Might take the hose loose from the intake manifold that supplies the air inlet to the compressor and ck for backflow out of it. Could be leaking...
Drove a 66 kw wrecker with one, not too bad empty. Would go home in it, kill it , go in the house go to bed and could still hear the darn thing...
If this is all you have they will get the job done if your not in a hurry. Cant expect too much they are 426 cu in displacement and made 238 hp. .
If you are able to crank it up once a month or so it should be fine. If not probably need to put a battery tender on it. 3 or 4 months is not very...
Spread axle rides smoother, easier to scale axle weights, but is harder to make tight turns forward or backward, really needs a dump valve. If you...
One of the j brackets on mine wore through the bushing and egg shaped the hole. I saw how high they were and decided to tig up the hole and...
If the springs are much shorter than the blue ones you may have trouble getting the hood to stay closed. I usually rock it about half way back and...