What was reason it was replaced? Doesnt look like you mentioned. Also, was clutch calibrated after new trans install?
Eaton Trans, has always taken 50W, but I think they changed it now to 40W, at least for the Automated trans. The Endurant in a class by itself....
Think the 384 is rated for Biodiesel? Davcos website is excellent for info. The Davco level goes higher as the filter clogs up, normal operation....
This quote is also directly from Cummins trainer " there is a threshold (between 5-30 seconds) with setting sensor code. If problem(fault) happens...
Just a suggestion because easliy 90% or more of the time i found it to be wiring over the last 4 years on PB and KW, but of course like...
Take a multimeter between the 2 wire terminals(blue is signal, green is return) make sure its a solid connection and dont damage female terminals....
You have a wiring issue most likely, ive repaired dozens upon dozens of those circuits, no egzaggeration
there are 8 fuses marked(that feed) chassis node in the fuse panel under hood. 2 of those circuits are for headlight circuits. one is for LH low...
Volvo's have real cheezy ignition switches, they will set FMI-9 codes in every ecu, every time it is started the counts will go higher, it will...
giving your gauges(assuming speedo and tach at minimum) quitting is associated(sounds like), shutting down, and no codes. possibly could be a...
easiest way I found to check a discharge air line for leaks is to adapt and back feed shop air from drier end of line into compressor with engine...
I meant to say, I would not just keep throwing parts at it(oops)
Try this out......
Goodysnap is on the money. It may be wise to get it properly diagnosed at a dealer using ESA. Replacing a blend door is a labor intensive job in a...
If you are using one of those cheezy plastic shaft tools to align, they can be troublesome, especially if you havent done many clutches, also make...
There should be an inline fuse holder along the harness on the d/s rear of the engine
