Install a manual fan switch, keep temps low on engine. The high causes them to fail. Install a copper ring instead of the liquid seal they use....
Had p269800 AHI MODULE was replaced, 7th INJECTOR was replaced, regen was done and gone
Mine wont run on volvo until i pull tractor parking brake. Then its goes.
HAD PROBLEM FIGURED IT OUT. Parking brake sometimes i would set only trailer. Just pulled tractor parking brake and away it went like a charm....
I have a d13 2008 volvo head i relaced need to know torque in ft lbs plz and sequenece preferably not angle tightenening does snyone have that? I...
Can anyone tell me i hve a 2008 volvo d13 and replaced head and i need to know torque on head bolts in ft lbs plz i know sequenece but not ft lbs...
After 3k in $$$$ $3,000 spent to find loose cover sorry
Aftermarket fridges do drain batteries. Original volvo fridge will not. That is the short and simple answer. Friends aftermarket drains after one...
I used deep cycle batteries for a test run started a d13 volvo in -6 Fahrenheit...interstate batteries offers agm 950cc for 160 a piece bought...
Looking @ a volvo 2015 its got a tranmission ATO2612D in it which is overdrive. The rear ends are 2.64. The hp is 455. Curious about longhauling...
Sounds like your soot level sensor going out had mine read 160 threw a regen needed then flashed then derate mode wothin 2minutes did regen but...
Friend had issue with gas pedal going out after 3k was found that ishift top of the tranny cover had become loose causing pedal to completely be...
Overheating. Have manual fan switch barely keeps temp down. what IS NOT the cause Compressor head gasket Injectors cups Thermostat Egr cooler...
Not hydrolocked but is leaking fuel into chamber...done injectors and cups more than once just trying to find the leaking fuel into chamber...
Would it enter right below the top oring was n the gap? I have what u call hydrolock but it hasnt burnt a piston yet...taking off injectors how...
Where is who located?
Idk i have an ishift for sale 509k miles complete running $4k thats the best deal around just look for them
anybody know where the fuel enters the d13 steel injector? One of mine leaks wont hold pressure is there a way i can check by myself? I can take...
Air governer valve is my opinion...cheap maybe $20 somewhere in that range n goes out causes different scenes sounds like it
So a permenant fix for everyone......i have copper washers...we replaced cups with graphite paste lasted two trips...put copper washer forever fix...