https://cdllife.com/2019/trucker-loses-life-helping-unload-steel-beams/
please explain
@pete1990 ... maybe this has all ready been discussed, in any case, my brother had a flat he was buying from mercer and this company bought it....
anyone in the group have a gen2 dynasys apu? if so, what are the parameters in the picture i attached refer to? every once in awhile the apu will...
@TruckerPete1990 ... it look something similar to this?
I installed new cab bushings in my '03 379 and now the clutch has no free play. The cab had shifted quite a bit with the old bushings and I'm...
have a look at this website ... Rawze.com: Rawze's ISX Technical Discussion and more
that nut bouncing around sure made a very unsettling noise, thought i had a more major malfunction. not that this wasn't of importance
was concerned about hitting nut with impact and over torquing it due to the fact 120ftlbs was max torque per bendix.
the key for the keyway got buggered up because of the gear being loose. fixed that and when gear was reinstalled, we heard the gear bottom out and...
Not really ... plus where this happened i was fortunate to have a local dump truck company nearby that helped me fix it. they didn't have anything...
The nut that holds on the drive gear for air compressor came undone. The air compressor is a rebuilt bendix TU Flo 550 on a C15. Compressor was...
purchased an ecm from here when i had a n14 celect ... http://www.heavydutypowertrain.com/shop/enginecomputers.htm
yes
inside tire wear on wide base tires, front drive axle ... recent 3 axle alignment, new wheel bearings and new power divider, shocks little over...
yes, also be prepared to let whoever does your hoses know how you want the fittings clocked, should you decide on using the crimp on fittings.
I had American Hose & Rubber Co. here in Tucson make everything up for me
@ prerunner404 ... the hoses and fittings are from Parker and are crimped on
thought i would share how i did the new fuel hoses ... under the truck, at the "T"'s, the same 90 degree sweep was used.. now i have to wait til...
Got all my new fuel lines replaced, now its time to get truck fired back up. How should I go about doing this properly so I don't inadvertently...