Common leak!! Oil weeps between the block and spacer plate gasket. Permanent fix is to coat the spacer plate gasket with a sealant before...
A boost leak will cause a turbo to pass oil into the intake because lack of pressure on the seal. I would pressurize your charge air system and...
They were lipe ones. I did call setco and got them to send me a new throw out Brg for one of there failed units and I put it in, it didn't last...
If it was me I would put the Chinese on the drives and michelins on the steers.
Sounds like it might have a boost leak with those low pressure readings does it have a check engine light on? I would check out the basics...
I believe what you are hearing is turbo stall, that is when the turbo momentarily stops and makes a coughing sound out of the intake. It is caused...
Well let me give you the whole story then.... I bought my first lipe about three years ago after reading on here how good they were and thought...
I have installed over ten lipe clutches in my fleet and are now replacing them between one and two years for throw out bearing failures. I never...
Does any one have the part number for the updated bolts and torque specs? Thanks in advance.
Check the trailer light cord for a short from the right turn wire to the to the brake wire. That is probably the most common place for it to short...
I have run a few lipes in our trucks and the engagement isn't bad if adjusted properly and the pedel is stiffer but the throw out bearings do not...
Try loosening up the bolt that goes through the hanger for the rebound bumper it will pull the bolt holes together and you will fight trying to...
So is the ecm on your engine a 40 or 70 pin? 40 pin has the plugs coming in from the front and the 70 pin has them coming from the side. We got...
I have to agree I think it will melt the oem duct work
I don't know for sure but my guess would be the fuel rate is higher when it is acting up because the ECM is trying to maintain a constant rpm or...
Possibly a bearing going in the trans most likely the one on the main shaft between the main box and auxiliary section
What make of transmition do you have? If its a eaton there is no seal on the input it has a reverse spiral cut into the input shaft that pushes...
Look in the dash for melted connections had a 08 Pete do the same thing with the bunk light coming on by itself ended up being a corroded and...
I know a guy with a fleet of heavy haul trucks with nxs acert's in them and he had one spin a bearing after 600,000 the other upper rod brgs...
I would bring it to another shop to get a second opinion that engine has been around since the late ninetys you should be able to find a...