@Heavyd I bought a new tcm from allison,I gave them the CIN and it came programmed. I installed it and it solved the problem. I can't thank you...
I'm going to get a tcm and I will let you know if that solved my problem Thanks again for your help
Is this what I need?[ATTACH]
On pin 8 I get 2.4 and on 28 I get 2.6 and ohms from 8&28 I get 58 ohms. So you think I should order a tcm? Where is the best place? Thanks again...
I'll do the data link test and report back Thanks for your help.
Today I noticed you can start it and it's fine within 10 minutes it'll buzz and say electrical issues, switch off and it takes maybe a couple...
On the power pins at the tcm 70&10 read 12.14 but 63 only reads 11.74 with key on same reading with pin 9&69 ground .those readings are with the...
What reading should I get on the data link pins ? If I set my dmm on ohms I don't get a steady reading on pins 8&28 it ranges from 1.m -3.m with...
[ATTACH] I scanned it with a prolink with allison and this is what it says
So if there are no codes reported in the tcm and the light test is good I should replace the tcm? Can I get a used tcm or does it need...
My transmission has the t-handle shifter, it's not the digital display push button my auto has a shifter cable. The PRND that I'm referring to is...
@Heavyd I have a 2012 4300 durastar with maxxforce DT and allison 2200 the other day I was driving and buzzer sounds and I look at the dash and...
What was your issue if you don't mind sharing.
