Working on a MBE4000. Had a wrist pin bearing fail. Replaced the pistons, rod, liner, and head. The liner i got for it had a groove for an o-ring...
Clutch and input kit were all new eaton parts. Putting a new install kit in again since we have it all apart. Spec of end play is 0.004-0.020" it...
I have a Kenworth T680, just put a clutch and suitcase kit in. Left the shop and driver came back next day with a rattle/ bearing noise coming...
Update. Truck finally came back. Removed the oil cooler housing and it was clear and oil cooler was clear. Put new oil cooler in as had it here....
Have an 03 sterling acterra with a cat 3126 that will not start after sitting overnight. Once it starts, it will start all day fine. Thought it...
Not yet, truck had to take a load. Hoping when it comes back I can get the oil cooler off. Thats about where I am at. The water pump I originally...
Was the oil cooler plugged and had problem flowing coolant out if it? Thats what im leaning towards as its the only part of the heater I haven't...
Swapped out the heater core out of a sister truck that is down and hooked back up the sleep lines and still had no heat. Almost less than with the...
Well so far I have bypassed the bunk heater system by running a hose off the cab heater core outlet to the water pump and swapped in a known good...
Engine temp is good, gets up to 170-180 and stays there. Has pressure in cooling system after running it. Both shut offs on the oil cooler and on...
I have a 2016 389 glider with 12.7 detroit that has no cab or bunk heat. The blend door is moving all the way. Only has 70 degree temp on the...
788083 last 6 of the vin. I found a diagram online that says it is for a c12 and that pins 12 and 18 on the chassis ecm connector are for the...
I have a 99 KW T800 with 9NS C-12. The speedo is very bouncy while driving steady. Speedo was replaced a few years ago with the newer style...
Ended up backing pin 87 out of the fuse panel and everything worked as it should. I didnt cut any wires, just pulled the pin out so it doesnt...
Ended up bypassing the starter interupt relay behind the cluster. Even with multiple good test relays it wouldnt start. Put a jumper wire in place...
Working on a 2012 Peterbilt 386 with Paccar MX13. When trying to crank it keeps dropping power to the "relay"/solenoid on the starter. I can put...
I have tried with both switches unplugged and with both jumped and one then the other unplugged and still wont trigger the relay. Have tried...
I have a 94 International 9400 I am working on with no ac. The freon is full. Fuse for ac and relay are good. I have power at pins 30, 86 and 87...