If there is a system problem it defaults to having the fan run all the time to prevent overheating. There are 2 coolant sensors, 1 for the gauge...
Yes, air can cause chattering of the cylinder or valve body. Not lifting a load all the way is typical for a low fluid level or air in the system....
Where is the oil coming from, looks like a leak. [ATTACH]
Obviously check the fluid level. Very/most likely it is getting AIR in the system. That probably has some crazy bleed sequence. What did the bores...
Recap: there were no problems and you replaced the switch because it was broken. Now you most likely have a short to ground as the fuse blows. The...
Take a small punch or similar object and place it in the white hole of the old broken switch and see if you can operate it, moving it between...
Make sure that the piece sticking out goes in the hole. See pics attached. It appears that the plug can be installed either way on the switch, one...
Post a picture of both the front and back of the switch. Also, a pic of the connector/wires that plug into the switch.
What's more insane are the actual bills if something happens. I had no health problems and still don't. In December I had a pulmonary embolism...
Just another wrong way driver.
Re-read your statement. You are saying a pulsing noid light means there is a problem. Should it not be: If the noid lights are pulsing you ARE...
Would your insurance cover getting the truck to a shop? Call Cummins and tell them your problem, ask them if they could send a tech out to you.
I don't think you need to go to a WS dealer. Emissions should be covered by engine manufacturer. If Cummins call the nearest dealer or Cummins...
You mean DEF heater unit? If you have a 2024 is this not under warranty? What engine? If Cummins you need Insite and can get a basic version for...
You have the short stroke chambers. Under no circumstances should the orange be showing if the brakes are properly adjusted, the angle is at 90...
Did you watch the video in post #4? He gives you a measurement range to cut the rod. I would start with the shortest cut first and connect...
brake-school.com/bsrepo/video/VID-2020-013/properly_cut_ pushrod_clevis.mp4
Should be a ground wire coming from the headlights and turn signal that is attached to the frame. Check and clean the ground wire.
Wow! So clean that I can't even see it. Or is the the glare that is blinding me? Ok, it just showed up.
Do you have a Davco fuel water separator? They have a plastic ball check valve at the inlet to the filter housing. Run a hose from the inlet at...
