One notch on what? The pitman arm? From what I recall when I did the crosses in the steering shaft only goes on one direction.
To do this I probably should take the drag link off as well? I might try that and see if it will rotate both ways the same amount.
yes they are. There is another mark but it would be way off one direction
To the left I am but to the right I am not. It’s like the gear “bottoms” or runs out of rotation before it gets to the axle stop.
I have a few questions. I am working on a ‘92 Kenworth C500 but they are similar to the T800s. I am trying to get a tighter steering since it...
Thank you. Our ‘06 t800 with 18sp will go in with torque off and clutch released. Grinds just for a second. Most likely not the best for it but...
AModelCat I’m having this same issue and I appreciate the advice. I am also looking at why my PTO will only go in if I am completely stopped. This...
Thank you. I am going to install new thermostats since I have it off as well.
@wore out do you see anything that would lower the pressure or should be replaced?
I have finally got around to pulling the pump and backing plate. Attached are the pictures of each. Not knowing what exactly good or bad is like,...
Does anyone know what gauge and sender is correct for each other? I have a 144455 sender and a Q43-1090 gauge. Is this correct? It is in a 92...
What controls the fan? Truck is a 92 that had an N14 and is swapped to a 2WS 3406E. My fan comes on at 200 and off at 195 but I think those two...
Just to update this thread. I have replaced the radiator and while doing so found a crack in the ata and replaced the fan with a bigger one. I am...
I know this is an old thread, but I have a 2ws 3406E that is doing this. It will run just fine on manual but when on automatic it will kick on and...
Thank you for your advice.
I have a couple studs on the manifold that are broken. I was wondering what all you guys replace when doing it. I’m not sure if a manifold is...
Does anyone know where to find the cover for the pedal on the williams? I am doing this swap on a 23 right now and would like the kenworth cover.
Is there a suggested radiator manufacture? I know I have heard about Detroit Radiator but are there any others that I should get a quote from. I...
YES THERE IS NOTHING BETWEEN EITHER.
Radiator is not ruled out yet. I live in Washington state so yes a lot of hills or even mountains. I pulled Blewett pass yesterday and the day...
