A to Z repair 615 Industrial Rd, Carlstadt, NJ 07072 2015079896 It seems to have good google review. And someone has recommended this shop to me...
You need to check the pair of small wires for the ecm that connect to the battery terminals for tightness. If they are loose you will lost engine...
It is my fuel filter housing. There is a crack along the side from the bottom going up.
Hi I have a 2005 with D12 engine it has around 900k miles. Anytime when I turn off the engine and try to restart it under 10 minutes it would...
It seems very straightforward. It looks like a I just have to replace the regular wabco slave cylinder with another wabco that have air assist...
Too high tire pressure on the rear tandems. Try to keep them at only 100psi.
I just don’t want to end up like that guy having to use an extraction kit to get the nuts off. Don’t think I can handle removing the pulley while...
Maybe this one? SOEXM15 Snap-on tools Metric 15mm Flank Drive Plus 12-point Combination Wrench NEW 2019 | eBay
Is this the right tool for this job? 14–15 mm 12-Point Metric Flank Drive® High-Performance Standard Handle 0° Offset Box Wrench Snap-on Store
Yes there is enough room for open end wrenches but. All the nuts are very tight and I worry about rounding off the nuts using open end wrenches....
[ATTACH] [ATTACH] My problem is I can’t get any wrench onto the bolts with the studs sticking out. The hub is blocking when I try to put a wrench...
The fan hub bearings are gone on my 2005 with a Kysor fan clutch hub. There are 4 (15mm?) nuts holding the hub on the bracket onto the front...
Front cab ac heat unit doesn’t use a blend door, it is controlled by a coolant valve to the heater core. All the air goes though the heater core...
I think depo is a pretty good aftermarket brand from Taiwan. The other one is Engle eye also from Taiwan.
I have a similar problem with my 05 but the last few days the ac actually have worked flawlessly when the outside temp hit almost 95. Usually in...
The ac actually worked completely fine the last couple days with outside temp over 90 for some unknown reasons. The moisture indicator on the...
Just want to clarify when the compressor was working I got nice cool air. It would cycle on and off normally. when the compressor decided to quit...
Hi, I have a 2005 630. The ac compressor would intermittently quit for a few minutes for a few times every hour even with the temp knob turned to...
I am just curious about the filter prime switch on the dash. Is the fuel prime pump by the fuel filter housing going to make some noise after...
With the weather so nice today in Jersey I finally able to get it done this afternoon out in the parking lot. It took me from noon to around 4....