I had read somewhere that some marine mechanics will rebuild the z482 for cheap. Maybe try there?
They're pretty much the same truck with the exception of the cab and sleeper. I like the T660s larger Studio Sleeper. Skip the couch, though....
Yep, but that's for a 53' trailer with the roll past option ($$$) and the front door.
Eew! I can't imagine tarping this time of year or middle of summer. If it was just the heat/cold I could handle it, but the wind pisses me off...
You can see why you can't turn while the kit is open.; [IMG] Trailer open, full view; [IMG] Roll past kit. You can see they have to cut...
It's now $374/wk when you include tax (rent is subject to sales tax). That does include all maintenance including tires, and all flatbedding...
Quick Draw. He's a nice guy.
I have an 18" king pin and the rear axle is set to be just barely CA legal. If you're hauling heavy, yes, it is useless. I usually don't haul...
I misunderstood the problem. You could run with a container under the tarp as long as you have the roll past option. The tarp would only take up...
35" at the tail or 35" at the top of the arch?
Drag is worse compared to an empty flat, but compared to a flat with anything that catches the wind it's better. I haul lots of stuff that would...
It's not a bad solution. The only time it's a real pita is when the load is up to the step. It's really hard to pull from the front because of...
You can't run with the tarp on the top deck because of the turning issue, but you could, in theory, pin it in place on the first 10' the bottom...
See where the bottom of the tarp ends up if you have everything rolled forward? Take a look at the difference in tensions between a QD and a Roll...
I would go with a Quick Draw for all of the reasons that Jfaulk99 stated above. I should say that the new Roll Tite functions much more like the...
Back when I used to pull heavy van loads I would carry a big rubber mallet just for occasions like this. Just start thumping from the back side...
You can spec a trailer with different lengths of slider track. Also, different manufacturers use different hole spacing.
Did they also measure you bumper to bumper?
I have a 110" sleeper on my T600 and a 53' step deck. I have very few issues with length, except Canada is a no go. To tell the truth, it...
I did mine because of a mechanical failure in the turbo and because I already had a Power Pup. At this point I could take it or leave it. My...