My 93 357, DD60 12.7, Pete is in the shop, I had them install DDEC IV, replacing the DDEC II, ecm and harness. I was having cruise control issues...
I have a 1993 357 Pete, I use the cruse control to govern rpms when running the pto for the wet kit. I have been getting the cruse cutting out. I...
You might check out Michigan trucks, there log trucks gross 165000 lbs with proper axles. Many double frames with 18 speeds
I have a 1993 357 Pete with 12.7 DD60, I have been slowly losing the tach function. It started acting up with the needle bouncing around. Later at...
We have alot of salt on our roads in the winter,rust between the starter and the block ,the alternator would put out 14 volts when grounding the...
I have a 12.7 in a 93 pete, had wierd things going on such as low voltage high water temps etc. The ground cables go to the starter from the...
I had a bad sensor on output shaft on transmission cause that problem.
a loose yoke in the drivetrain will vibrate, when you let up on the throttle, feels like a u-joint going out
I have a 93 357,DD60,18 speed fuller, 45000lb rears, airtrac, The engine has 40000 miles on rebuild. 400000 miles total. Is a glider an option for...
I have a DD60 in a 93 pete, had all kinds of erratic electrical bugs. The alternater tested fine, but gauge would show low, the same at the...
Thanks DL 550CAT, The peterbilt parts guy did not know. Logging Pete
I have 93, 357 Pete with Eaton axles, tags are gone on the axles. The line sheet list them as DC451P front driver,RC451P rear driver. Anybody know...
Thank you country 29 and notarps4me, had a bad sensor and clutch switch needed adjusting. I have not had a chance to get on the computer for a...
I have a 1993 357 Peterbilt. 60DD, 18 speed. The cruise control stopped working. The control for the fast idle/pto works. Where is the clutch...
