usually the gaskets are intact....the problem is cummins torque spec is only 35 ft lbs on those bolts. then if you have to shim the followers, it...
don't defend volvo. they are horrible and evil people. there are nothing good about their engines.
Holset should take none of the blame. Cummins owns Holset....try looking it up some time. Holset builds the turbo to Volvo's specs....it isn't...
I highly doubt its another ECM. Like the other guy said, look into your parameters to make sure the fan logic is set correctly. It could also be...
On an M-11, the intake pressure sensor and intake temp sensor are two different sensors with separate codes. So this code will not effect the fan...
if you have an air leak from plumbing out of the governor, like say to a fan hub, then these kind of leaks can only be heard with engine running....
for an oil cooler, it would be about 10 hours labor...maybe a bit cheaper since on a 770. that is one hell of a bill i know, especially since my...
not yet, have only seen one in person
As far as the new volvo engines, don't bother. I work at a local Volvo dealership and these new engines don't stay out of the shop. Yesterday, I...
Concept gears are not based on horsepower or torque. They were something Cummins tried out to lower gear train noise and that's it. They did...
All of there automotive engines....including ISB, ISC, ISL, and ISX. Remember they did away with the ISM and now the ISX comes in two different...
Just got done some training on 2010 Cummins and I tell ya, they don't look all that bad. I think these engines will definitely be better than...
I know the new '07 Cat and Cummins don't adjust boost by adjusting the fins. They adjust boost by sliding a ring over the turbine. The more area...
you should also look into aftermarket head gaskets. when cummins changed the head gaskets a few years back, they have been having trouble with...
all m-11 cylinder heads are 4 valve per cyl. the only upgrade needed is a block stiffner plate for the higher horse engines. without it, block...
if you need someone to rebuild the engine, i can do it for you if you want to bring it up kansas city.... $2000 with unlimited mileage labor...
i hope you guys aren't serious about taking detroit over an n-14. i've never seen so many engines fly apart then the series 60. depending on the...
Curious if anyone here has tried them out. Everytime I go road test one of these, it is a treat. I know if I was a truck driver and had one of...
I've seen air getting sucked in from the hand pump and the check valve on the return side being plugged. Most likely the dealership went thru the...
Cummins shouldn't be acting up like that, or cutting out in some gears. Most likely your EGR valve is getting ready to go out. Probably the...