If it only bent exhaust valves I would check the jakes also to make sure they did not hang up
Yes it sounds normal as it has a fuel press regulator on the return line. Should be about 32 psi under full load at 1500 rpm. That is if it is a...
if you have an air supply problem turning off egr will not cure it you need to check your air supply to the v pod and make sure it is a dedicated...
A 1993 ddc s60 should be a ddec 2 if it still is, the best they came with that year was 450 hp @ 1450 tq..Custom ecm tuning can be set to whatever...
nows the time to upgrade your ddec 2 to a ddec 3 you will have to get a detroit dealer to reprogram it after they get the ddc factory to change...
who did the tune?
after reading your post again you say it sounds different at times does the boost change also and does the pyro go down when it pulls good?if so...
poor injector atomization will cause a shake at idle and poor economy but still run ok .did you have the inj, tested when they were out ?what is...
to get 700 hp you will need a tuned ecm,but you can make them pull good with a few parts ,we used to put in a ddec 4 500 hp cam ,move the fuel...
possible connection issue or faulty low voltage module!as your ecm is resetting itself as if you were turning the key off and on.also if your...
call detroit they will give itto you 1-800-445-1980 you need the engine serial number on hand
tps ..throttle position sensor..
also oil temp,code will cause shut down .try unplugging it as it will change the code to a sensor fault and not shut it down, or change the shut...
ddec 3 and 4 will run your engine but the boost sensors are different.so you will have a boost sensor code if you put a ddec 4 ecm on a ddec 3 ....
call the ddc help line at 1-800-445-1980 it is on your valve cover sticker
can you be more specific
to adjust the backlash the fan hub mount bracket would have been removed for access to the idler gear hub,there are a few specialty tools needed...
idler gear backlash should have been checked if a new cyl, head went on .as the new head may have been resurfaced changing the deck height causing...
i'd lean towards the overspeed also ,but if the idler gear backlash was too tight [new cyl,head] you could have broken some teeth causing out of...
yes it can be easily set with a laptop or prolink and no it will not hurt your engine .have one with 1.2 million on it with 790 hp