Thanks. I will look them up this week. I'm more than likely going to need the top tank just because it's getting lots of rust...
Just wondering if the radiators that are advertised in the truck paper are any good? If so which one is realible? I have a 99 3406e 550hp in a 379.
Well my relay for the A/C compressor in my fuse box is clicking? Why would this be? Freaks me out a bit. Don't want flames shooting out of there..
Well today before having the radiator pulled I bought a digital thermometer that went to 320°. Pulled the cap off and the water is reading...
Could it be a bad gauge. I put a thermostat in the antifreeze and it gets to just above 180 and my gauge is showing 200°. Changed the water sensor...
That same temp is what I'm used. Last year running running Washington to Texas I don't remember it getting this warm. I'm running the same route....
What I've been noticing. Is even at idle its sitting at 200° or whatever I parked at. Are my thermostats not opening up all the way. During the...
I cleaned the radiator by stopping at a car wash big enough for my truck. Ran the truck with the fan on and spayed with water for about ten...
I also had the fan kicking on/off until I covered the section of the ecm that goes by the thermostats. That fixed that problem. Also the fan was...
Well as it gets warmer so is my water temps. It was mostly during the day and cool off at night, but not anymore. It's hanging out around...
It's probably your high pressure switch. Usually on the driver side of the radiator on a A/C line.. I'm not 100% sure that's the one because there...
Any suggestions on the best way to flush out the radiator? Also any good radiator shops in theDallas area?
I finally got to replacing the switch for the fan speed and no luck.. Where would the resistor switch be located..
By the way it's a 99 pete 379.. I think that info might help.. :0/
My heater/ a/c blows only up to the windshield. I've just replaced the selector which controls what vents the air blows thur. No luck. Is there...
Well the air to air was changed three months ago. He says his manifold pressure doesn't drop below 15psi. He's thinking the turbo might be his...
Well the sensors checked out good.. I'm going to tell him to check the air to air thanks..
Yeah that was another thing I told him. To take a laser temp gun or even a thermometer to manually check. Thanks for the replies...
The old one he cleaned with some cleaner sold to him by freightliner and then changed out the thermostats, then the radiator and pump..
