Is there a specific reason you are hung up on finding a 11cm housing vs the 16cm housing? Is 500whp your initial goal with room to grow?
I wasn't too concerned with priming the fuel system. My truck has always been easy to prime the fuel. Because of the potential for the...
Due to lack of a better suggestion, I'm going to try to make an adaptor to backfeed oil through the port that normally goes to my oil pressure...
Here is a little update. Thanks for all the advice. I adjusted the valves, cleaned up and reinstalled the valve cover with a new gasket (most of...
That's what I figured, but wanted to ask just in case. I also ordered an injector height tool, but it might not come in until the engine is back...
The owner of the company I'm leased to has 3 or 4 cabovers as company trucks and usually drives one himself. All of them are Petes and KWs. He...
Either way, I plan to check it after the first oil change which I will be doing after the first week I run with it, regardless of how many miles...
That is kind of my mindset to a point. Since its in a 379, the valve cover comes off fairly easily with it in the truck though. Its good to know...
Im putting a used 12.7 Detroit in my truck because the one that was in it locked up a couple weeks ago. The truck is a 96 Pete 379 with a 12.7...
Thanks. I noticed there seems to be a lot less pictures on this forum than the ones Im use to posting on, so I wanted to add a picture of my...
Since I've been a lurker for a while now, I decided I needed to make an introduction post. I live in southwest michigan. I drive a 96 Pete 379...
