Bosch p pump is an inline pump. Shut down solenoid has 3 wires. Hold in, pull in & ground. Pull in is a high amp circuit that's energized when...
Could be an electrical issue like JB7 pointed out. You could remove the wire from the solenoid after using the governor & see if the condition...
It sounds like the engine has a Teleflex governor added to the pt pump. The loader would need that or a mvs pump. Are you certain the Teleflex...
If the problem is only with the rear axle & the front is fine perhaps it wasn't built with spring brakes on both axles? Some have spring brakes on...
That isn’t a fuse
I believe it's called a shunt. Small wires on each end connect to the amp gauge.
Sent you a pm
The pictures you posted do not show the correct position to measure the timing
What timing spec are you trying to get to? The measurement is taken at .203 before tdc.
What do you have against the stc system?
You should absolutely time the cam followers using the correct tool. All 3 followers can have different thickness shims. What spec are you timing...
I'd look for a poor ground to the frame from the batteries. Generally the frame grounds connect at the starter ground lug. Battery ground cables...
I'd isolate the engine from the truck from a fuel standpoint. Connect a funnel & hose to the fuel pump inlet hold it higher than the engine to...
To me that engine sounded pretty good. Sounds like it has an exhaust leak. Likely at a manifold to produce that type of noise. Low compression...
Midwest ecm repair. I've had great luck with them.
The tin one is the better choice. Much easier to service if you do need to take it apart & reseal it. Which may not be a bad idea anyways. The...
Why?
We have one customer with a mechanical n14 on a chipper. They run great & sound awesome. It's a pain getting quality parts but it'll be nice to...
The weather pack connector in your last photo is the one you want. The 3 wire connector would go to an ambient air pressure sensor if the engine...
The plug you’ve circled in that photo isn’t a datalink. Key switch, engine brake, coolant level & fan clutch wiring runs through that plug.
