I just singled out a BXS and made 6NZ out of it. As a BXS it got 4.6-4.7. As a 6NZ its getting 6.5. This is in a 379 PB pulling a cow trailer.
Tons of them ! The 6TS came after the 5EK.
Were you loosing coolant before doing all this work to the engine? Did you have a blown head gasket before? You could have dropped a liner causing...
9 3/4"- 9 7/8" from bottom of frame to center of axle housing.
And cost about $5500.00 apiece !!
You need to flush it some more. 12 gallons of water and 1 hour is not enuff. Fill it with water and liquid dawn. Turn the heater on in cab and...
Yes I'm pretty sure you can.
No I do not work for Conway. I work in a dealership. I don't know much about them but I know they are expensive.
Esa is a software program we use on the multiplex wiring in the newer trucks.
You use it in place of just one of the batteries. It is used like a booster. All of Conway's new trucks have them installed in them from the...
Biggest piece of crap KW has ever put on 10 tires !!! JMO
Fuel psi should be 75 @ idle and 90 @ WOT. You should have higher fuel psi than that at 1500 rpms. Have you cked for sucking air in the fuel system ?
Sounds like it could be freezing up.
Thats right, CAT will only sell ET to dealers and fleets of more than 10 trucks.
A 2WS is a has a 70 pin ecm. A 5EK has a 40 pin ecm. If you wanna easy swap you need a 70 pin ecm engine, if not you are gonna have to change some...
Heard today KW is tossing round the idea of building gliders again. This info came from a very good source.
Sharp car !!!
Best electronic engine Cat ever built was the 6NZ !!
The resistor is under the hood in the heater box on a T2000.
I agree with SmokinCat. You got yourself a 3406c prefix 3ZJ.