I use a 3000 watt inverter, and the manufacture specifies 4/0 awg cable in order obtain full wattage. 4/0 would be similar to the size cables...
Maybe the sensor is half pluged up that determines the soot level, could explain the various readings. How is the fuel economy, and engine power?...
I agree with the above sentiment. In this situation the government forced companies to close and people out of work, I can't blame people for...
Taylor & Martin has a lot of low mile fleet trucks at there auctions. I guess it depends what your looking for.
Did you try pulling the fault codes off the display if so please post them.
I have driven a volvo and international with this transmission. When the transmission functions correct it is one of the smoothest very nice...
What model truck do you have?
You can retrieve fault codes using the two buttons on the shift lever (this method doesn't work for freightliner). See attached picture.[ATTACH]
The bottom line is you need to find a dealer that has some experience with the ZF Meritor Freedomline they need to have the software to...
. Make sure the truck has air in the tanks. Stand outside the truck by the drivers door. When you turn the key to the first position with out...
I don't know what you mean by the EE light. If the gear display and or the F N R on the shift stalk doesn't light up sounds like the transmission...
There is a clutch actuator on the bottom of the transmission it requires air pressure to work. The transmission has its own dedicated air tank...
." But my ominatrax isnt reading truck movement 99.9 percent of the time also my oil temp,trans temp,rear axle temp gauge show no temps or...
.What exactly is your problem at this time? I would assume you checked the fuse box already. That connector on the drivers side handles all the...
The connector has extra holes in it, you could just slip the wires wires straight through the existing connector if you don't want to drill...
You may want to unhook the that cab connector I have pictured in the 1st post and check and make sure none of the terminals are corroded or...
I had an international 9200, the factory coax for the cb and am/fm radio ran to a spliter then out to the single cb antenna. This caused low...
I would be questioning your mechanic on everything he did every detail. Because something he did changed the pre start check by the ECM at least...
pull the acces cover from the bottom of the trans 4 13mm bolts. un hook the air line to the clutch actuator, take a small pry bar, pry the clutch...
I am asking for any current or past contractors that have run this truck, their opinion of the D11 engine? Can the d11 pull 70-80k up a steep...
