Checked cruise brake switch is good. All the switches on the air manifolds check out good. Truck has brake lights. Truck only has 1 speed sensor...
I have a 99 Pete 379 c15 with no cruise at all. Truck has new clutch switch. Ohmed on/off and set/resume dash switches are good. Checked relay on...
Nope still messing with it. Traced and ohmed all wires from speed sensors through body and engine wiring harness. All check out ok. Had local...
Clutch switch is new, adjusted properly, and will cut off high idle when depressed. Thanks.
Maybe someone can help. Been scratching my head pretty good on this on. Idle can be adjusted from cruise switch, but truck has NO cruise while...
update in case someone has similar problem - injector wiring harness took in engine oil and it migrated into engine wiring harness - had to...
More information has surfaced. Truck started having trouble after SRS and TRS sensor replacement. Reinstalled old sensors and truck is still the...
Hi. I have a 2008 Freightliner Cascadia Detroit 60 that has a very rough engine idle and will die. I have a code reader, but no type of scan tool....
Late update - turned out ECM tune was WAY to hot for this truck causing overheating and piston scoring - Costly lesson - "tuner" said truck needed...
1,3,4,5,6 con rods and bearings were replaced with cylinder packs and have 3,000 miles on them. #2 cylinder pack has 50,000 miles. I know...
Block was tanked upon crank replacement at machine shop. Pulled off pan. #5 piston scored. Pulled oil cooler jet looks good and clean. Fuel...
We have performed all work inhouse. Not that I'm above owning up to fouling something up. All jets and passages looked fine. That was the first...
Have a 99 Pete 379 with 3406E ESN#1LW32335. Truck has 1.8 million miles. About 100k ago the original crank broke in half. Failure was credited to...
Update. ECM was bad. New $$$ouch$$$ ECM repaired truck. Just for anyone else that runs into this the truck was running perfect then out of nowhere...
checked all fuses and relays - after checking wiring and power to ecm everything going into ecm is ok and nothing is coming out - looks like ecm...
I have a 2008 386 with Cummins ISX. Engine will crank over, but will not start. The "stop engine" red warning is on and has a "J1939 FAILURE"...
ended up just putting new stocker on due to time restraints. truck is fixed. thanks.
Hello. I have a 08 386 Pete ISX Cummins that I am "fixing" the emissions equipment on, but it also has a bad stock variable turbo. Does anyone...
Hi. Ive been a lurker for a while and gained a lot of info. Thanks everybody. Have an 08 pete 386 that is making me pull my hair out. All...