No i have not. The truck only gets about 20,000 miles a year and have not had the pan popped off to check the bearings. Oil temp came down some...
Pulled the plug on the front diff. Dirty as hell and bunch of metal on the magnet. Dropped the power divider....shes junk. Hopefully a rebuilt...
Yes.....but from the shop that did the work. They are a well respected place that does all the driveshaft balancing and shortening in house....
Any ideas?
I bought a truck about 2 years ago. 2006 KW W900L(850,000 miles). C15 with and 18 speed. 4-bag flex-air suspension. Mainly using it for hauling...
Does anyone have a picture of where the factory guage port is?
Want to install a fuel pressure gauge on my MXS C15. Was looking for a picture or a description of the best spot to t in for the gauge. Was...
Thank you far all the replies. Might be next week before I will get a chance to dig in to this truck, but I will report back when I figure it out.
I've been having some issues with the fan/heater control on my 2006 W900. When I first start out in the morning, every once in a while the fan...
I have a 2006 w900 with the new style dash. The last 3 mornings after starting the truck up, the blower will not run and the entire back light...
Center punched and drilled.....worked good. Thanks guys
Need to remove some Huck rivets holding on a visor on a 2006 KW W900. They appear to be stainless. I have been told to either center punch and...
That's what I will end up doing if I cant figure it out. Would be nice if it would read out in the dash like its supposed to. Wasn't sure if I...
Bought a 2006 KW W900 with new style dash. Talked to Kenworth and asked about where the outside air temp sensor is. They said it was built into...
I was told that if there are marks on the cam that it didn't pay to change the roller. Camshaft would just wear the new roller.
Have a 2006 KW W900 MXS C-15 I recently bought with 830,000 miles on it. At 756,000(November 2012) I have paperwork on some work that Ziegler Cat...
Quick update. Changed the bypass/regulator valves and springs in the oil filter housing with no change. Took valve covers off and found a blown...
How much clearance do I need on the bottom? I can get a fingertip underneath it.....I'm thinking that might be enough?
Serpentine belt. When I put the radiator braces back in sucked it back a tad and I gained a little clearance. Hopefully it will be fine
Had that off to get the shroud on. They are not slotted.
