E. F. Johnson Messenger 352, 352D Bar none the best. Astatic and Telix swiped the mike switch but use poorer mike elements. Uniden picked...
Level 1 : Right and just as soon as the DOJ closes the border and stops mexican drug gangs from robbing and shooting people here, as well as...
I'm trying to figure out with confederate in the name why you are harping on rebel CB outlaws running shops? OK I read the start of the thread...
rabbiporkchop, did Hard Drive tell you about my perfected Echip? I reverse engineered one the last time I saw a 2970 DX N2. Uses a 4069. Since I...
"May I ask a simple question? Why is everyone making such a pissing contest out of this?" WA4GCH "That I will agree on" Interesting statement...
"really doesn't really support your claim" Right, and you may wish to read the 'Saga of Conjugate Match' by W2DU. I saved you the search here it...
"Take the time to read my post I NEVER said that ...." I did not type the words you say you never said I copied and pasted them from your post....
Two things, one Mike tried the rear idea. His company is quite picky complaining about blemishes on the finish where the coax runs along the side...
WA4GCH "YOU push the point that playing with coax and placing it in the radiation part of the antenna system is as good as doing it right and...
"SO ...... on 10 meters ..... lets use a reasonable band .... I can take a 440 mhz wip which would look like .01 ohms on a 50 foor RG-58 coax...
No bottom line exists if you have not actually done a scientifically controlled test and published your findings. In all the years I have listened...
"Yes, it's in essence acting as a dummy load per se" Actually the coax becomes part of the radiating system, not a dummy load. Reading the series...
I highly doubt the radio has any thought whatsoever. If after years of daily talking the radio still performs as well as it ever did what then...
WA4GCH has a good answer. I was just going to say the answer to "When is over-modulation inevitable" is whenever you have a super whack pack job done.
One can only assume you have never studied the schematic to a typical CB. The diode is in parallel with the supply input. So called 'jumping it'...
Was true until he installed the bigger fuse. At that point the now shorted protect diode either burned open allowing reverse power to many...
Solder the feet on the 10.24 MHZ crystal. Sound could be another solder joint problem. You probably run the radio in a location subject to much...
Originally Posted by Channel Jumper [IMG] "I got a Question and I would like a honest answer. Is it that truckers are so G.D dense that you can...
The sheer ignorance I read in posts here is truly beyond understanding.
"It also says nothing about a Ham being involved" The mention of the guy being a ham was interestingly enough on the site EHAM.net. "It's...
