I have a 93 Kenworth W9 with the 15spd trans(10 regular speeds and 5 spd deep reduction). The truck has been setting awhile and I went to take it...
Turns out the forks were jammed in the pressure plate. Was able to get those out and the clutch is working fine now, wood blocks are gone. Thanks...
Clutch discs are installed correctly and the forks are in front of the bearing
Got the everything together with the new clutch and have it installed into the truck but I'm having issues. Went to go hook the linkage up then...
Scary part is the rods and caps were engraved from the factory with the numbers on them. As for the cooling jets I don't believe they were...
At the advice of the folks on this board I'll be tearing back into it to check the protrusions, the motor has NOT been run yet only turned over a...
The old clutch had a grease line but the new one just has a zirc, should be fun to grease that one up! So it sounds like somewhere between...
Putting a new clutch on my old KW and I noticed that the manual does NOT say anything about torque specs for the 8 clutch pressure plate bolts...
I hear ya and totally agree. Normally I'd go back and tear into it but I don't have a torque wrench that goes high enough to do the head, we had...
Hired a kid fresh out of diesel mechanic school to do an in frame on a CAT 3406. Didn't realize until after we got the cylinder head in place that...
