bearings most likely, very common to fail
Thanks guy, I was looking at a used truck with this setup but I backed out cause of other reasons.
10spd 3.42 gears 22.5 lp ISX Anyone know where my rpms would be at running in tenth going 70 and 75 mphs? Thanks
Does anyone have a diagram or picture that points out all the sensors on a cm871. Both sides would be great.
This works did it today
Got it from a freind but I think he downloaded it from quick service online. U have to pay for the fleet account which I think is like $500+ a...
I looked up some wabco info and it said YU2 BU2 must be on the lift axle. Im going to switch some wires around and see what happens.
Hey guys, I installed a center bag lift kit on a spread axle reefer and Im having ABS problems. When I lift it after a few miles the trailer abs...
I got a Neway RL230 spread what lift kit would you guys recommend? Same as a Holland spread mentioned earlier?
Anyone try the new Bridgestone R283's?
UPDATE!!!!: So I uploaded the latest CALIBRATION that just came out 4/04/13 (sorry I forget the # Ill try to post later) and truck is running...
Ill check thanks but I think it ends in 47.
Update: So I changed out the dosser, it looked real bad had over 100k miles on it. Truck took a 2000 mile round trip, everything fine no check...
Yea the doc was cleaned also. That other code is 2637 Catalyst Face Plugged - Root Cause Not Known. It came up inactive six times and then 1691...
Everything is new. All the temp sensors, turbo and actuator, egr, egr differential, and the dpf was cleaned about three months ago. This same code...
Could be but it's about three months old.
Can anyone tell me where the temps should be at on an active regen? I keep getting code 1691 DOC below normal operating temp . I cleared code and...
Whats the best way to hook up a dump valve on the trailer to the truck?
I have the same problem, happens when pulling a heavy load and building 20+ psi. Ill let go of the pedal and itll stop, also no check engine light...
