Could be broken Iva housing, or bolts / studs, sometimes they won't log a code.
You need to pressurize the intake system and sprey all boost hoses, the cac and bellows with soapy water, it could be a crack in something opening...
First step is to check the radiator cap make sure the rubber seals are good and it has spring tention . Then you need to pressurize the cooling...
http://m.youtube.com/watch?v=FTEXLzPjPXw C15 - standard flow inj - 550 file in ECM. - stock wastegated turbo, it does pretty good with tourque...
The thing that most guys don't realize is a 6NZ with the right 550 file in it, stock turbo, and if your lucky enough to have a decent set of...
If you have swapped the complete housings around and it's still throwing the fault for #3 actuator, then you need to look at wiring, have you...
Start with the oil cooler, could potentially be the head or head gasket.
If you press down the solenoid button and nothing works, it sounds like you have a problem with the jake housing itself. Did you put a full...
Bright side is .... With it being done out of frame and the block is decked and line bored, you are starting fresh with nice flat true surfaces....
You need to start with the basics. Your fuel supply right from the tanks. Any restriction there will cause the injectors to play up. From there...
That will do it. You will find if the injectors are not seating properly, the o rings you just replaced won't last long. There was a guy on...
Sometimes it's not what ya know its who ya know.
You need to replace the aluminum elbow that the cap goes in. If you look in where the cap goes, there is suppose to be a little tag that wears...
50 ftlb is all that is required. Next time you remove the plug it will be tighter anyway as the steel plug reacts with the aluminum thread and the...
[IMG] Dummy injector and pressurize the cylinder with nitrogen is the best way.
[IMG] 1 1/8 - 12
I've helicoiled them before with success. But the best way is to remove sump and get a spud machined with the correct thread and weld it in.
http://www.williamadams.com.au/Products/Cat%2520On-Highway%2520Trucks/Pages/CatTruckModel.aspx
It's what the Australian built cat trucks are running. They are still using a NXS acert and have changed the software to run dpf and changed the...
Kurt I'm sure you have heard that in ozz the NXS in the new cat trucks are coming out with twin dpf, that has to choke them up, there are a few...