I'm aware of the front eating up tires but if you could lift the back and run on the front when empty it should get around better in town and...
I have a fontane 48' spread. My front axle has a lift for when empty. My question is is there a reason most spread axles I see lift the front...
I've used Detroit Radiator a couple times with good luck. I bought their heavy duty one for a KW W900. I'm was running close to 800hp and it did a...
Bgexpress would you happen to have the part numbers for the offset shackles? I'm sure a few of us on here would like them. Also did you do...
Its a 5EK engine. Im not at the truck currently. I'll get it later today and post it .
Does anyone know if the flywheel housing between a 3406b and 3406e are the same. I need to replace the one on the E model because of broken engine...
Where you located.
My 97 w900l cracked the frame there as well. I welded it up and put a insert in it that runs from the front where the horns bolt on and goes back...
if its a factory 455hp that hasn't been rebuilt and upgraded it will have one piece pistons in it.
I've used IPD in a couple b models and have never had any issues. I do use a genuine cat head gasket kit though. Some of the b models have been...
I don't think I've counted gears since I was learning to drive a set of sticks. That was 20 years ago. Hell I can't even tell you what gear I'm in...
My 5EK is a pre-emission engine as well. Stopped in to Western States Cat in Meridian Idaho for a water pump replacement, I come walking out of...
Only problem with dynoing it is cat will put the those #### low NOx settings in it automatically.
If the frame looks like that I can only imagine what the wiring maybe like. I bought a truck recently that I had driven its whole life up till...
I'm not a big fan of the couch or the studio sleepers myself. I like the look of a mid roof better and I don't carry that much stuff with me...
The clutch brake would only cause it to grind when putting it in gear from a stop. This is assuming it has a non synchronised transmission. I'm...
Flatbed the $4000 quote from the KW dealer is with me doing all the prep and finish work. I called to the dealership this morning and talked to...
I have also had shops replace the clutch brakes before and Leave pieces of the old one sitting in the bellhousing or in the cross member under the...
Does it grind going into gear? Why did the clutch need adjusting. What your describing sounds like its a piece of the clutch brake. If so this is...
The only reason I was considering having the shop do it was in case of it leaking. I'm doing all the wiring and heating and cooling removal and...