Truckers Report Jobs

Find Trucking Jobs

Company Driver Company Driver Dry Van Dry Van Flatbed Flatbed Refrigerated Refrigerated Specialized Specialized Owner Operator Owner Operator
More Trucking Job Searches ⌄ Fewer Trucking Job Searches
⌃

Search Results

Search Again
Page 1 of 5
  1. shivver
    Post

    How much paperwork do you do for a load???

    I am a company driver too....sometimes I feel my ppw time is excessive...
    Post by: shivver, Mar 8, 2016 in forum: Experienced Truckers' Advice
  2. shivver
    Thread

    How much paperwork do you do for a load???

    So how much paperwork do fill out per load, and what is the average amount of time it takes you to fill it all out and send it in? EXAMPLE:...
    Thread by: shivver, Mar 8, 2016, 8 replies, in forum: Experienced Truckers' Advice
  3. shivver
    Post

    Tunnel Restrictions In Baltimore MD

    The only hazmat allowed is Liquid Asphalt...use 695
    Post by: shivver, Dec 24, 2015 in forum: Tanker, Bulk and Dump Trucking Forum
  4. shivver
    Post

    1099 Contractor

    Scam
    Post by: shivver, Dec 16, 2015 in forum: Experienced Truckers' Advice
  5. shivver
    Post

    Difference between PDL lock and off road switch

    The owners manual reads like stereo instructions, for those old enough to know what I am talking about...
    Post by: shivver, Dec 16, 2015 in forum: Questions From New Drivers
  6. shivver
    Post

    Driver ran over himself

    It wasn't his fault, he used 3 points of contact...
    Post by: shivver, Dec 8, 2015 in forum: Trucking Accidents
  7. shivver
    Post

    Starting from a stop with a full load on a hill

    1. There is no gas 2. Do you know what a clutch brake is? 3. Don't give advice if you don't know what you are talking about. To the OP, if you...
    Post by: shivver, Dec 7, 2015 in forum: Experienced Truckers' Advice
  8. shivver
    Post

    slow hazards

    Can you say standing 105 permit?
    Post by: shivver, Dec 6, 2015 in forum: Intermodal Trucking Forum
  9. shivver
    Post

    Schneider Bulk/ tanker school expectations

    When it gets below 25, I NEVER shut the truck down.....asking for trouble there
    Post by: shivver, Dec 6, 2015 in forum: Tanker, Bulk and Dump Trucking Forum
  10. shivver
    Post

    Passed weigh station

    ########
    Post by: shivver, Dec 6, 2015 in forum: Experienced Truckers' Advice
  11. shivver
    Post

    what bad trucking habits have you acquired

    Trying to stay in the right lane....on the NJTPK....very bad habit....talk about getting freight-trained!
    Post by: shivver, Dec 2, 2015 in forum: Experienced Truckers' Advice
  12. shivver
    Post

    Fifth Wheel Adjustment

    If it's too far back, it will beat you to death on rougher roads...and it's bad for the suspension
    Post by: shivver, Dec 2, 2015 in forum: Experienced Truckers' Advice
  13. shivver
    Post

    Fifth Wheel Adjustment

    It doesn't matter where the pin is,,,,use common sense. look at the back of the trailer, for they are all different. You want to mimic what is...
    Post by: shivver, Nov 27, 2015 in forum: Experienced Truckers' Advice
  14. shivver
    Post

    Schneider tanker L/P

    all of their single dip chem trailers look like they rolled down a hill...just sayn
    Post by: shivver, Nov 20, 2015 in forum: Tanker, Bulk and Dump Trucking Forum
  15. shivver
    Post

    Running thru coop

    this thread is a waste....read the signs and drive ur rig...
    Post by: shivver, Oct 25, 2015 in forum: Experienced Truckers' Advice
  16. shivver
    Post

    NE Regional

    Good advice Pintlehook....also, note that if you will be running the turnpikes and thruways, your fuel options may be limited. NY service plazas...
    Post by: shivver, Oct 6, 2015 in forum: Experienced Truckers' Advice
  17. shivver
    Post

    If you are attending a J.B Hunt Orientation

    you went thru a lot of bs to work for the worst company in the industry.....geez!
    Post by: shivver, Oct 1, 2015 in forum: Report A BAD Trucking Company Here
  18. shivver
    Post

    I give up....

    yes...recieve is the issue....grounding, bonding, and even trying dual antennas didnt help....i tried all advice...but the demon prevails....the...
    Post by: shivver, Oct 1, 2015 in forum: CB Radio Forum
  19. shivver
    Post

    ok I am getting addicted now...

    some things are worth it....
    Post by: shivver, Sep 29, 2015 in forum: CB Radio Forum
  20. shivver
    Post

    I give up....

    would grounding the radio to a chassis bolt help? Right now it is grounded to the neg batt terminal
    Post by: shivver, Sep 28, 2015 in forum: CB Radio Forum
Showing results 1 to 20 of 100 Next >
Search Again
Page 1 of 5