1997 peterbilt 379 coolant temperature

Discussion in 'Peterbilt Forum' started by pres1034, Dec 15, 2014.

  1. pres1034

    pres1034 Bobtail Member

    5
    0
    Jul 12, 2011
    atlanta, ga
    0
    Hey guys, I have a 1997 379, and lately it has been running just fine and suddenly the temperature will go up to about 210-215 and the lights and bells would sound. If i go to neutral and raise the engine, the temp begins to fall immediately and will continue to fall to about 150 degrees. It will do this empty or under a load. It does seem to do it less when I'm climbing grades, or I'm just giving it fuel to pull the load. Sometimes, it will begin to fall back to normal before I have time to do anything. I have a new radiator, 3-month old water pump, clean fins on cac and condenser, new thermostat. Any help would be appreciated. The engine is a Cat 3406e 4758 hp.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. rodknocker

    rodknocker Road Train Member

    1,242
    584
    Dec 18, 2008
    Southeast
    0
    Sometimes a thermostat will be bad right out of the box. I think 195 degrees is where the temp is normal and 210 is a little high but shouldn't set off any alarms. Cats run hot.
     
    baha Thanks this.
  4. baha

    baha Road Train Member

    4,137
    2,837
    Jul 25, 2013
    ga
    0
    rodknocker is correct a new thermo. should not let temp go as low as 150, its slow to move and causing prob.
     
  5. 201

    201 Road Train Member

    12,782
    26,305
    Apr 16, 2014
    high plains colorado
    0
    I agree on the thermostat too, I've replaced several on my pickup truck, and I think they are all junk. Check the coolant with a separate temp guage, and see how far off the stock one is. It could be an air bubble in the system.
     
  6. Flightline

    Flightline Road Train Member

    2,345
    1,167
    Oct 1, 2011
    Almost There
    0
    I have the same engine and was told by cat, there is only a 190, 185, and 205 thermostate available thru cat. And have only heard of problems with aftermarket thermostates.
    I would consider changing the engine sensor which is located in the head, just above the thermostate housing.
     
  7. Longhood379

    Longhood379 Medium Load Member

    389
    125
    Nov 30, 2009
    Cremona AB
    0
    Check the line from the surge tank to the back of the waterpump , if this line gets plugged all kinds of weird crap can happen and it is easier than just ripping the temp regulator out.
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.