On my Classic on the bottom of my floor(Cab and Sleeper) are two steel channel supports. I have corrosion between the supports and the aluminum floor. Couple holes in the sleeper floor also. Has anyone dealt with this problem? If so how did you handle it? Lookin for input here! The supports run from front to rear. One on each side.
2000 Classic
Discussion in 'Freightliner Forum' started by The Admiral, May 13, 2017.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I would first check with the Freightshaker Stealership and see if any of the pieces you need to replace is available separately.
If not, depending on how bad the cancer is, you may need to cut out and treat the cancer, fabricate new channels and weld in new floor panels.
You may be better off trying to locate a rust free Classic Sleeper Cab Shell from a scrapyard and replace the whole Cab.Last edited: May 14, 2017
The Admiral Thanks this. -
drill the rivets out and bolt it together with washers or plates on each side
-
Hi, I'm trying to locate the fuse for replacement on the right side head lights. Does anyone know were to fine it?
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.