2007 VNL670 Tranny Problem

with bad x-y motors TCU power connector may be overladen and melt. so loose connection - more heat on contacts, more problems with x-y motors))) and TCU may fail. so closed chain circle)

 

look at my post same issue it was the xy shifter.no codes on my ecu.because of shifter.make sure is not just the sensor on that shifter save u some money.sensor is $80 shifter is $750

 

[h=3]Bulletin: TAIB-0832 - Eaton[/h]

 

Pablo you seem to be very knowledgeable can im having same issue...it just started today...dash board kept saying check tranny at next stop...at first there wasnt a fault code now i have mid130 pid161 fmi 1... Before i started out today i had to jump start the truck fyi... The problem is intermittent... And help would be greatly appreciated...

 

I know this is a little late, mine was doesing same, it was the wire harnes to the zmteck