2016 International prostar Dump Suspension flashing

Noobtr · Dec 16, 2022

Heavyd said: ↑

Check this thread out, and read through it. Lots of good information including part numbers. The solenoids do overlap each other, so you can't just remove the two centers ones, the one to the left also has to come off. With an over current code, you could have a shorted solenoid, or the board it plugs into could be internally shorted. You won't know until you pull it part and test it. The solenoids plug into the board by spade connectors, which are sometimes corroded in behind. So you could be looking at replacing everything, be prepared.
2010 International Prostar Dump Valve Blinking
Click to expand...

It was one of the solenoids which was getting stuck sometimes, so thanks for the help.

Noobtr · Dec 16, 2022

Inderjit said: ↑

If you look at the body controller in DLB when you activate the switch you should see a check mark by the corresponding connector terminal at the body controller if the switch is working. If I remember correctly!
If I remember correctly in DBL you can drag the switches to different positions as well.
Click to expand...

My dlb didn't let me drag switches, but turned out 1 solenoid was getting stuck and after replacing it working fine now. Thabks for help.

Log in or Sign up

Forums

Find Trucking Jobs

2016 International prostar Dump Suspension flashing

Noobtr Bobtail Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Noobtr Bobtail Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Log in or Sign up

Useful Searches

Find Trucking Jobs

2016 International prostar Dump Suspension flashing

Noobtr Bobtail Member

Wait, employers can't reach you!

Noobtr Bobtail Member

Wait, employers can't reach you!