I do have 4 batteries but probably need to look into replacing those as well with something of more quality and will do everything else as well with replacing the fuse n most likely the cables too n cleaning it up further more. Thanks
3000w inverter unknown problems?? Or APU or GENERATOR??
Discussion in 'Ask An Owner Operator' started by The Highway Hustler, Jun 25, 2019.
Page 2 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Jus checked out the links those are the exact same type fuses except they was 200 n clear case i had with previous installment worked n ran perfect even with 3000w inverter for a while. Eventually had to replace it called PowerDrive they recommended sum BS but I gotcha I’ll follow through n try that thanks for the advice n sense of direction driver..86scotty Thanks this.
-
Take the fuse link out and see how it works.
The Highway Hustler Thanks this. -
Naw there’s no corrosion n volts don’t drop as i stated on my dash below 12.5. I believe it’s that polished turd truck stop PowerDrive BS inline breaker I bought on the fly to quick fix the problem most likely n need to get a better grade cables. Because it’s clean in there little grimy but no crazy build up. Sound advice tho regardless..
-
Nooooooo!
-
Imma just replace the cables and PowerDrive inline breaker with something more quality as recommended disconnect everything clean it up around all terminals and run it see how it performs..
-
Gone cost me less then a hundred bucks n maybe 2-3 hrs of my time moving at a slow pace..frito bandito Thanks this.
-
The low voltage alerts are usually under 12 volts, so if it reads 12.5 on the dash it's voltage drop across high resistance power connections.The Highway Hustler Thanks this.
-
The alarm go off on the inverter I’ve summed it up based off everything that it’s my connections because it’s not getting the required power from batteries to properly power the inverter..
-
Oh boy here we go again.
First the dash volt meter isn't the indicator you want to use, it is useless.
Second buy a multimeter, read the instructions and check the voltage at the following places, at the batteries and at the inverter input itself. That will tell you what's going on.
DO NOT REMOVE ANY FUSES OR CORCUIT BREAKERS, NEVER.
your problem is more or less the batteries.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 4