33 HP 2 issues

Discussion in 'CB Radio Forum' started by _33, Jan 14, 2019.

  1. Jan 14, 2019 #1
    _33

    _33 Light Load Member

    82
    22
    Dec 6, 2018
    Atlanta, Ga
    0
    I have a Galaxy 33hp 2. In the morning when I first get in my truck I have the RF gain wide open, my squelch date wide open and yet there is zero static and no Voice receive. When I key it up I get a high SWR tone. As the morning progresses the static comes in, the SWR tone goes away and my receive improves. Any thoughts?
     
    _33, Jan 14, 2019
    _33, Jan 14, 2019
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Jan 14, 2019 #2
    jessejamesdallas

    jessejamesdallas Road Train Member

    1,416
    855
    Oct 3, 2008
    Republic of Texas
    0
    how cold is it outside?
     
    jessejamesdallas, Jan 14, 2019
    jessejamesdallas, Jan 14, 2019
    #2
  4. Jan 16, 2019 #3
    _33

    _33 Light Load Member

    82
    22
    Dec 6, 2018
    Atlanta, Ga
    0
    Pretty cold. Around 34-36 degrees
     
    _33, Jan 16, 2019
    _33, Jan 16, 2019
    #3
  5. Jan 16, 2019 #4
    jessejamesdallas

    jessejamesdallas Road Train Member

    1,416
    855
    Oct 3, 2008
    Republic of Texas
    0
    Could just need time to warm up...or a cold solder joint somewhere.
     
    jessejamesdallas, Jan 16, 2019
    jessejamesdallas, Jan 16, 2019
    #4
    rabbiporkchop Thanks this.
  7. Jan 17, 2019 #5
    Slowmover1

    Slowmover1 Road Train Member

    1,491
    1,210
    Oct 25, 2015
    Fort Worth
    0
    Engage the choke and let it run on high idle while you fill your coffee thermos before scraping ice off the windshield.

    (I don’t really miss those days, but the New Yorker with its optional gearing and police-spec V8 440 was great to listen to as it woke up. Subtle changes. And —time to leave — slip the cassette into the AM/FM/FM-Stereo player to let The Presidents Own play, “Anchors Aweigh” as you cast off the mooring lines and rang the engine room to bring in the TorqueFlite).

    If this is what’s needed , think of it as part of performance.
     
    Last edited: Jan 17, 2019
    Slowmover1, Jan 17, 2019
    Slowmover1, Jan 17, 2019
    #5
  8. Jan 17, 2019 #6
    _33

    _33 Light Load Member

    82
    22
    Dec 6, 2018
    Atlanta, Ga
    0
    Also, as I speed up my static gets worse. If I run a direct hot and ground to the battery do you think that would help? I think I am getting a lot of engine noise.
     
    _33, Jan 17, 2019
    _33, Jan 17, 2019
    #6
  9. Jan 17, 2019 #7
    Ridgeline

    Ridgeline Road Train Member

    22,726
    123,456
    Dec 18, 2011
    Michigan
    0
    Please start with your antenna, get it checked by someone who knows what they are doing with an antenna analyzer. then go from there.
     
    Ridgeline, Jan 17, 2019
    Ridgeline, Jan 17, 2019
    #7
    rabbiporkchop Thanks this.
  10. Jan 18, 2019 #8
    _33

    _33 Light Load Member

    82
    22
    Dec 6, 2018
    Atlanta, Ga
    0
    Thank you for the help and advice.
     
    _33, Jan 18, 2019
    _33, Jan 18, 2019
    #8
  11. Jan 18, 2019 #9
    Powder Joints

    Powder Joints Subjective Prognosticator

    7,988
    8,406
    Sep 25, 2007
    Rosamond, SoCal
    0
    If you have a spare radio swap it out see what the changes are, Sounds like a cold solder or maybe some caps going away. I'd probably try refloating the board, or fire it up bench with a can of freeze spray in one hand and a heat gun in the other, also pressure on the board can show a bad soler.
     
    Powder Joints, Jan 18, 2019
    Powder Joints, Jan 18, 2019
    #9
    rabbiporkchop Thanks this.
  12. Jan 22, 2019 #10
    _33

    _33 Light Load Member

    82
    22
    Dec 6, 2018
    Atlanta, Ga
    0
    And what do you mean by pressure on the board can show a bad solder? I'm learning but some of these responses are still a little over my head.
     
    _33, Jan 22, 2019
    _33, Jan 22, 2019
    #10
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.