34065ek on my 388

Almost there but I need help from you guys
It’s a 3406 with a 40 pin ecm (not j1939) compatible
Everything is working on the truck, the only thing that we can’t figure out to work is the odometer and the trip miles hours of the engines are there everything is there working perfect.
I was told that I need to set some parameters off from the CECU vía ESA FROM PACCAR IF IM NOT WRONG
Such as
Vehicle Software Parameters
For proper functionality, please set the vehicle parameters as follows using ESA:
Make sure to set engine make to the proper engine (for DDEC use CAT)
Outside Air Temperature (OAT) is set to: SENSOR
RPM sweet spot set to: OFF
Water-in-Fuel sensor set to: OFF
Brake lamps on with retarder set to: OFF
DPF functionality set to: OFF
DEF gauge is set to: OFF
Clutch switch set to: OFF
Engine shutdown protection timer set to: OFF Downhill speed limiter telltale set to: OFF
Engine de-rate and shutdown warnings set to: OFF Green House Gas (GHG) set to: OFF
PTO total fuel used diagnostic set to: OFF

Any info will help thanks in advance guys