I just installed a cb in a 09
i used a new mount with a Francis 4.5ft
when I put it on without a ground wire my swr was just over 2.1
and I was getting out about 1.5 miles
i put a ground wire on that connected to the factory ground strap
and my swr dropped way down (these readings were taken off of the
built in meter on a cobra 29)
But now i am not getting out at all
Any ideas?
Antenna issues
Discussion in 'CB Radio Forum' started by Drumbum, Jul 23, 2012.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
09 what? Got a picture??
-
Sorry 09 prostar. I'll take a pic
-
-
I am guessing he hooked the other end of the wire to the antenna hot as he does not specify with clarity. He only states "on that". This would explain the no distance comment. As well it explains the internal meter zero, ohms law would indicate a dead short on the coax gives zero volts for the meter to work with. Remember how the internal meter circuit is configured. He needs to connect the antenna end to the bracket itself not the hardware in the center.
-
I wondered about that but didn't know for sure.
-
Thanks for the replies
I connected the ground wire from the new antenna mount to the current mount where the original ground strap is -
This does sound like what is happening though because my swr seems very low but the signal is not going anywhere.
-
Well I unhooked the ground I put on and im getting
Out now not sure how far and my swr meter still
Reads three bars up well under 1.5 on a cobra 29lx
Going to try new coax tonight when I get to the ts
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.