I replaced all baterries and cleared all codes. Electrical components are conected to lots of things. You get lots of codes. You have to figure it out...
Thankfully replacing baterries helped me and now I get no codes, and truck starts fine!
anyway to bypass low voltage sensor?
Discussion in 'Volvo Forum' started by sbaumann14, Jan 15, 2012.
Page 2 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
i replaced my batteries and the same started i disconected the ground on the batteries and let it sit for five minutes then reconnected it i still have low voltage issues but the low voltage modual works they are in canada about 500 bucks
-
-
Hi,
Is there any other way? I don't wanna try shorting the low voltage protection relay it may cause a problem. -
loose wire was small wire coming off batteries. looks like about a 14 ga wire that was waaaaaay too long and looped back and forth on itself. cut out some extra wire (must have been a kink in there somewhere) and no problems
KB3MMX Thanks this. -
I had the same problem and loose wire was from battery. Thank you all!
KB3MMX Thanks this. -
-
Got ready to go to work started the truck went put diesel on my way back from truck stop I went in derated mode to 5mph I try to park regen it didn't work. next morning I try to start truck just all the dash board lights came on & off accept battery warning left on but no crank low voltage alarm went off . I check all of battery connection cleaned it . Went got new starter replaced it. but no progress . Now it say at engine ecu. Opration failed.i checked fuel in 7th injector thing is dry.
I primed it still didt work. any advice on what should I check next? I would appreciate it. -
-
How do you check for fuel at 7th injector??
KB3MMX Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 4