Can a auto shift be converted to manual?

Discussion in 'Trucks [ Eighteen Wheelers ]' started by cat from the valley, Mar 18, 2011.

Page 2 of 2
  1. gonzo01

    gonzo01 Light Load Member

    Joined:
    Jun 14, 2010
    Messages:
    74
    Thanks Received:
    5
    Location:
    denver, co
    0
    Well thats too far for me to drive. What are you useing for a bell housing on the UltraShift conversions? I'd like to replace this one or convert it.

    thx,
    Dr. G
     
    gonzo01, Mar 23, 2011
    #11
  2. Pablo-UA

    Pablo-UA Road Train Member

    Joined:
    Oct 11, 2010
    Messages:
    7,604
    Thanks Received:
    1,642
    Location:
    Borispol, Ukraine
    0
    about ultrashift, the best way if to sell Ultrashift and purchase used 10 st transmission. Ultrashift cluutch kit is expenceve, used x-y motors may be easily sold, like controll units. Anyway used ultrashift is more expencive then used 10 st tranny
     
    Pablo-UA, Mar 24, 2011
    #12
  3. 2broke2payattn

    2broke2payattn Bobtail Member

    Joined:
    Jan 24, 2013
    Messages:
    22
    Thanks Received:
    3
    Location:
    Lubbock, Texas
    0
    Does the transmission case have to be drilled to install this range inhibitor valve? Could you explain the installation procedure and do you have a part number? I suppose the ECM out pin can be located with the proper wiring diagram.
     
    2broke2payattn, Jul 21, 2013
    #13
  4. 2broke2payattn

    2broke2payattn Bobtail Member

    Joined:
    Jan 24, 2013
    Messages:
    22
    Thanks Received:
    3
    Location:
    Lubbock, Texas
    0
    Does the transmission case have to be drilled to install this range inhibitor valve? Could you explain the installation procedure and do you have a part number? I suppose the ECM out pin can be located with the proper wiring diagram.
     
    2broke2payattn, Jul 21, 2013
    #14
  5. 2broke2payattn

    2broke2payattn Bobtail Member

    Joined:
    Jan 24, 2013
    Messages:
    22
    Thanks Received:
    3
    Location:
    Lubbock, Texas
    0
    Sorry for the double post.
     
    2broke2payattn, Jul 21, 2013
    #15
  6. cat from the valley

    cat from the valley Medium Load Member

    Joined:
    Dec 8, 2008
    Messages:
    469
    Thanks Received:
    32
    Location:
    jamaica
    0
    what we did was change the case and the back, reuse the gears
     
    cat from the valley, Jul 21, 2013
    #16
  7. 2broke2payattn

    2broke2payattn Bobtail Member

    Joined:
    Jan 24, 2013
    Messages:
    22
    Thanks Received:
    3
    Location:
    Lubbock, Texas
    0
    I have other trucks, and to my knowledge there is nothing to prevent shifting at particular speed.
     
    2broke2payattn, Jul 23, 2013
    #17
Page 2 of 2