I did a ultra shift swap to a manual trans bought harness for a manual trans cant get cruise to work do i still need to run it through vcu
Cruise mot working
Discussion in 'Kenworth Forum' started by Frghtr, Jul 13, 2017.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
what year truck is this most of the time KW have separate speed sensors for cruise control which they do not have in the unltrashift version since ultrashift transmit speed over datalink so see if you have a second plug on the harness for a second speed sensor, i have had this problem a few times when my guys do clutches and forget to plug them back speedo works but cruise and engine brake are a no go
-
-
You might have an issue with just the cruise side like the switch programming highly doubt they would run two separate switches for engine brake and cruise
Bean Jr. Thanks this. -
It worked fine until the clutch was replaced. Fast idle still works.
-
Than it has robbed a speed sensor Issue did u try to ohm out or replace sensor see if connector are mixed up with something else like reverse switch
-
To op, I didn't mean to hijack. -
Don't need ohm meter swap plugs see if speed working simple as 123
Bean Jr. Thanks this. -
I tightened it, and cruise works. -
usually sometimes it is stupid #### that will make big prblems glad you got if figured out
Bean Jr. Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.