Ok problem solved!!!! I adjusted my ride height with the leveling valve..... my question is... does this bolt thing come off??? If I can’t get it off and put it in the next hole down I can get a lower ride height... which I what I want. I’m roughly 22-23 inches from ground to deck on the rear.
Dropping neck on mechanical DD
Discussion in 'Heavy Haul Trucking Forum' started by nikmirbre, Jan 23, 2018.
Page 15 of 20
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I mean 22-23 inches from ground to deck at the rear of the well..... not the back deck
-
Just take that nut off
snowman_w900 and SAR Thank this. -
I wish it was that easy lol..... that thing is hard to get off!! I try holding one side with plyers and turning the nut....
-
Highest point here I’m about 13’8. Only scale I’ve gotta hit is the one at Tennessee/Alabama on 65..... if I can get that nut off I can get it about 3 inches lower
snowman_w900 Thanks this. -
That's a good way to strip it n that's about it.
2 wrenches or a wrench n a ratchet.
Or get a universal leveling rod n set to what you want.snowman_w900 and SAR Thank this. -
Yea I had a ratchet on the nut .... that other side opposite of the nut I just couldn’t get to stop turning. Yes I’m gonna get a universal leveling rod when I get home. It’d be much easier than fooling with this......
-
Btw the thing on the other side of the nut is round .... not stripped or anything it’s just round. So no wrench to put on there
Oxbow Thanks this. -
Pipe wrench
SAR, Tug Toy and snowman_w900 Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 15 of 20